Puch one speed E50 Clutch bushing. Comes with two lubrication holes.Dimensions:14.9mm Inner Diameter17mm Outer Diameter21.4mm Longm**Please be sure to check specs and understand you may need to ream or sand to fit perfectly. Recommended...
NOS Flywheel cover for Puch mopeds with an E50 or ZA50 engine such as the Maxi, Magnum, Newport, Korado, Dart, Swinger, Pinto, Freespirit, Kromag, MKII, Cobra
Dimensions:122mm I.D.124.5mm Inner Lip Diameter(refer to picture)140mm mount eyeletsAbout 27mm...
NOS starter clutch adjuster nut for Puch 2-speed ZA50 engines.*This is the adjuster nut only, as pictured.
NOS Puch connecting rod bushing. Comes with one lubrication hole.Will fit Vespa Piaggio mopeds such as the Ciao, Grande, Si, and Bravo. *Must have 12mm wrist pin. Dimensions:11.7mm Inner Diameter14mm Outer Diameter12mm Long**If you do not check the...
This tool is designed to bore out a new connecting rod bushing in order to fit your wrist pin. Old Puch mopeds used copper bushing in the connecting rod and when they went bad either this was used to remove the old one or used to bore out a new one...
fabric Puch logo with lightening bolt patch.Nicely made piece. Dimensions:84mm Long x 39mm Wide.
59mm fabric Puch logo patch.Nicely made piece.
54mm fabric Puch logo patch.Nicely made piece.
USED Puch start and stop switch. *Used and faded, but still functioning.
This switch is for the right hand side on many old Puch mopeds and may fit other mopeds as well. The base for this switch is not included.
Turn me on and turn me off...
Original Puch moped engine start / stop switch, made in Germany. Handlebar clamp included Run / Off only. Puch # 3184.108.40.2060
Original German made Puch Headlight Made by Niox. Puch logo stamped into the lens, high quality plastic lens. Very nice piece. Includes a 6v 15w P26S bulb, but you can also run a 12v. Fits Puch Dart known as the Mini Maxi in Europe, 1984-86...
NOS Puch Monza Tank Decal.
Comes with Two, one for each side.
Very old, May have a small bend.
Original Puch Dart known as the Mini Maxi in Europe headlight and speedometer shroud.
Please compare and be sure this is the fairing you need.
Original NOS Puch Headlight fairing found on the Macho, but also is good for Maxi, Tomos and many other mopeds with 5"round headlights. They will not fit the Bullet style headlights.
Puch # 349130503146
NOS original forks for Puch mopeds. This will fit the Maxi, newport and similar models.
Nice silver paint and rust free chrome.
Non-sealed Headlight socket Clip for CEV headlights.
Puch Part # 3220.127.116.117.1
CEV 2157B Headlamp found on some models of: Batavus, Beta, Bianchi, Cimatti, Fantic, Garelli, Intramotor, Italjet, Malaguti, Motron, Negrini,...