New decompression valve for Sachs 504, 505 engines typically found on the Hercules and other mopeds with the Sachs engine. If you notice it's tough to press in you must clean the port and may need to file and / or sand the valve collar to get a proper...
Replacement 39mm by 2mm GI style piston ring for Motobecane AV7 / AV10 mopeds. Please compare before purchasing.
*Sold as a single ring.
Replacement 39mm by 2mm FG style piston ring for Motobecane AV7 / AV10 mopeds. Please compare before purchasing.
*Sold as a single ring.
Replacement Vespa 38.2mm Piston Kit with 10mm Wrist Pin for Vespa Piaggio and Kinetic mopeds, such as Ciao, Citta, Si. 38.2mm x 2mm Dykes top ring with 38.2mm x 1.5mm FG bottom ring.*Please compare before purchasing, remember to measure your wrist...
New Motobecane spring bracket for the AV7 engine. Be sure to compare. The Av10 is not the same style bracket.
New Ina caged needle bearing. Made for Motobecane mopeds.
13mm ID x 16mm OD x 14mm Length.
Double ended cir clip for use with 10mm stock or performance kits. Made fore mopeds with 10mm wrist pins such as some Tomos, Puch, and Honda. Please be sure to compare before purchasing.
*Sold per piece*
New crank cam for your stock points AV7 or AV10 powered moped. The lobe(oblong shape) is what opens and closes your points as the crank spins.about a 12mm to 15mm taper.Uses a 26mm Puller.
New Airsal 70cc 45mm Cylinder kit for the Honda MB5, MB50, MBX, MTX, MT50 AC, and similar air cooled models.Comes with everything shown. Recommended Accessories:70cc Cylinder HeadAll MB5 related products
NOS Minarelli V1 cooling fan. You must make sure you have the same version as this to use it, code below.
105mm inner diameter.60mm eye to eye mounting holes.
Intake gasket for Motobecane AV7 powered mopeds. 1.5mm thickness.Recommended Accessories:Av7 SHA Intake
New 70cc head gasket for Av7 / Av10 powered Motobecane mopeds. This is the larger 46mm or 70cc size.
Recommended Accessories:Base GasketExhaust Gasket
43mm cylinder kit with 10mm wrist pin from DR Racing.This will work on all 10mm Piaggio, Vespa, and Kinetic mopeds. Will fit with no case matching, though case matching will increase performance.
43mm cylinder kit with 12mm wrist pin from DR Racing.This will work on all 12mm Piaggio, Vespa, and Kinetic mopeds. Will fit with no case matching, though case matching will increase performance.
You must measure your wrist pin...
Original Kinetic seal 24mm outer diameter, 14.9mm inner diameter with a 5mm thickness. Crankshaft oil seal for all kinetic mopeds. Will also fit, minarelli V1 output shaft and pedal shaft seals along with the morini m1/m01 output shaft sealThis...
New original 50cc cylinder head for all Kinetic mopeds, Luna, TFR, Magnum, as well as Vespa Piaggio Si, Grande, and Bravo.Kinetic # 03003246*May have some scuffs or marks from storage.