Super rare NOS original CEV rectangle / Euro style headlight. This version was normally found on Puch Maxi / Newport, Solo, Moto Guzzi, Benelli, Zundapps and Hercules mopeds...
New old stock 12mm wrist pin.
12mm Diameter x 30.9mm Long
This is good on Puch and Tomos 12mm con rods. Please measure and be sure you need this.
*Might need a polish from years in a bag on the...
Puch cylinder stud for E50 and ZA50 Engines. *Sold each*
Works on the batavus laura m48 engine.
Diameter: 6mm m6
Part Length: 104mm
fabric Puch logo with lightening bolt patch.Nicely made piece. Dimensions:84mm Long x 39mm Wide.
59mm fabric Puch logo patch.Nicely made piece.
New old stock wrench with an 8mm and 10mm end. Very strong and well built tool. These are NOS and may have some light surface rust.Dimensions:Overall length - 116mmhandle thickness - 3mmWrench end...
Original German made Puch Headlight Made by Niox. Puch logo stamped into the lens, high quality plastic lens. Very nice piece. Includes a 6v 15w P26S bulb, but you can also run a 12v...
NOS original forks for Puch mopeds. This will fit the Maxi, newport and similar models.
Nice silver paint and rust free chrome.
NOS Puch chain tensioner pair for you.
Slightly different looking than our other sets.
Awesome NOS Puch Bombardier decal. These were imported into Canada mostly and work on most Puch frames like the Maxi and Newport.
*Price is for EACH. This is the Right side...
For poppin bottles in Austria. Even has special gripper to aid with twist off American brews.
Non-sealed Headlight socket Clip for CEV headlights.
Puch Part # 3184.108.40.2067.1
CEV 2157B Headlamp found on some models of: Batavus, Beta, Bianchi, Cimatti, Fantic, Garelli,...
OEM Puch quality replacement chain adjuster set for Puch Maxi, Newport, Swinger, Pinto, Dart and Murray. Also works with others like the Lazer Sport 50.
Comes with two along with...
Puch cylinder stud for the Cobra and Monza models.
The bottoms are M8 thread and the top is m7 threading.
*Sold each*Please be sure to compare before purchasing
This tool is designed to bore out a new connecting rod bushing in order to fit your wrist pin. Old Puch mopeds used copper bushing in the connecting rod and when they went bad either this was...