Chrome performance upgrade intake manifold for Tomos A3 mopeds like the Bullet and APN6. This piston port style intake allows you to install a larger Dellorto carburetor using an 18mm shim. Carb hangs to the side.
Use this intake for Motobecane AV7 type engines. clean intake that fits the original 17mm Gurtner carburetor shim size.
Dimensions:ID=13mm OD=17mm44-45mm eye to eye
Tech Tip: You may need to file/ground down the top of the intake to clear the cooling...
Translucent green polyurethane oil injection line for mopeds and many smaller motorcycles, such as Garelli, Puch Magnum, and Tomos. Can also be used for the air injection on your intake or carburetors.
The hose has a 2.5mm I.D. with a...
Intake for bolt on Mikuni flange style carburetors 18-20mm only. Oil injection or boost bootle inlet on side. Can be capped off if not need. Fits: MB5, NSR50, NS-1 and similar engines.20mm ID.Dimensions:M6 studs with a 47mm spacing(center to...
Original Tomos straight intake with oil injection hole for Tomos mopeds with A35 engines.
ID - 12mmOD - 18mmM5 Oil Injection holeTomos # 227592
This is a original NOS Fast Arrow power box / boost bottle for 2 stroke engines Basically this chamber / bottle holds a charge of air and fuel mixture and his ready for you once you are back on the throttle. Similar setups are found on the Yamaha...
Athena Intake for Puch E50 engines.
Square port gasket.
Made for clamp style carburetors like SHA, but may work with others. Please compare before purchasing.
ID - 15MM
OD - 18.5MM
Type a description for this product here...
34mm Rubber intake coupler
32mm one side and 34mm the other - For carbs like Mikuni
MLM Mopeds intake for the Honda express NC50 NA50. Lets you mount a 15mm Dellorto SHA carburetor.
38mm-eye to eye / 15mmID / 19OD
Lever Choke SHA Carburetor
Athena Intake for Puch E50 engines. PHBG carburetors on ZA50 mopeds work with this intake as well.
Square port gasket.
Made for clamp style carburetors like PHBG but will also fit the VM18.
ID - 19MM
OD - 24MM
Use this intake to mount 15mm , 16mm SHA style or Amal 15mm or 17mm carburetors onto the Motobecane AV7 type engines. Great upgrade over the stock Gurtner carburetor.
44-45mm eye to eye
Tech Tip: You may need...
NOS 9mm Franco Morini intake for you M1 powered moped. Designed for the reed style induction if you weren't sure. The hole on side does not go through and is NOT oil injection.
Original intake if you just want to replace that lost or broken...
NOS 14mm Franco Morini intake for you M1 powered moped. Designed for the reed style induction if you weren't sure.
Works with 14.12, 15mm, and 16.16mm SHA carburetors. Just check for the right shim.
Puch PHBG intake manifold for Puch Maxi E50 and similar type mopeds.
Allows one to use a Dellorto PHBG clamp on style carburetor. Also will fit a Dellorto PHBG.
Flat mount intake works perfectly with Bing carburetor. A SHA or Amal can be used with some custom shimming.
Used on Sachs 504, 505 A and B cylinders that have the angled intake port along with the Athena cylinders. Two angles...