Puch NOS

Puch Maxi Rubber Fork Boot/Cover - Single

Original replacement Puch Maxi/Maxi N rubber fork boot/cover for the lower end of the upper fork housing. *Sold per piece*Dimensions:(approximate)32mm large end(top)28mm small end(bottom)

NOS Puch MS50/MV50 Fork Lock and Key Set

NOS Puch fork lock with keys.*Must compare before purchasing.  Dimensions:40.5mm Overall length4mm Wide block15.5mm Long block5mm High block26mm Long barrel12mm OD barrel

NOS Puch Turn Signal * Sold Each*

NOS Puch turn signal. Be sure to compare before purchasing. 

Original ULO Puch Turn Signal Lens Screw - Magnum

NOS screws for ULO turn signal lenses found on Puch Magnum mopeds. Could be used for other things.*Sold EachDimensions:24mm LongM4 Thread

Puch Gas Cap with Logo - 38mm Chrome

Great quality reproduction for your Puch moped restoration.38mm fits the Puch Magnum, Swinger, Freespirit, and JC Penny Pinto. Does not fit the Maxi or Newport.

NOS Puch Niox Headlight Socket / Bulb Holder

  Puch NOS Niox bulb holder / socket for Magnum mopeds. Puch # 349.3.53.819.2 Recommended Accessories:Ba15s Bulbs  

NOS Puch ULO Tail Light Lens - Fits Puch, Sachs, Honda

NOS Puch ULO lens.Fits Puch Maxi, Maxi Luxe, (Sears) Free Spirit, Sachs, and Honda PA50 mopeds. Must compare before purchasing. Includes mounting screwsULO # 2481015 / -ULO-248-R

NOS Puch 5 star Mag Wheel, Bare - Gloss Grey

NOS Grimeca gloss grey 5 star mag wheel.Only the bare wheel is included.  Dimensions:17" Diameter1.35" Width Recommended Accessories:5 star front hub5 star rear hub

NOS Puch 17" Snowflake Mag Wheel, Front - Bare

NOS original 17" Grimeca Puch Snowflake mag wheel.  Includes only the wheel, nothing else, as pictured. 

NOS Puch Bicycle Pedal Crank Arm + Sprocket Assembly - Chrome

Original Puch crank arm and sprocket one piece assembly for bicycles.  Maybe you are lucky enough to have a classic Puch Fahrrad. This part may be for you.   Puch # 600.1.12817.2

NOS Puch Maxi S Pedal Crank Arm Assembly, One piece - Chrome

NOS Puch Maxi S pedal crank, crank shaft, and arm 1-piece assembly.    Puch # 349.4.42.103.0

Puch Freewheel by Esjot - 23 tooth

Top quality 23 tooth chain wheel / freewheel.  Came standard on Puch.  Can be used with others with French thread.  Made in Germany by Esjot

Puch E50 One Speed Moped Clutch Bushing - 22 x 15 x 17

Puch one speed E50 Clutch bushing. Comes with two lubrication holes.Dimensions:14.9mm Inner Diameter17mm Outer Diameter21.4mm Longm**Please be sure to check specs and understand you may need to ream...

NOS Puch Moped Flywheel Cover - Red w/ Black Emblem

NOS Flywheel cover for Puch mopeds with an E50 or ZA50 engine such as the Maxi, Magnum, Newport, Korado, Dart, Swinger, Pinto, Freespirit, Kromag, MKII, Cobra Dimensions:122mm I.D.124.5mm Inner Lip...

NOS Moped Wrench 8mm & 10mm Ends - Vintage Austrian Werkzeuge by Stubai

New old stock wrench with an 8mm and 10mm end. Very strong and well built tool. These are NOS and may have some light surface rust. Will clean up quickly with a little oilPerfect for your tool pouch...

NOS Puch Za50 Starter Clutch Adjuster - Nut Only

NOS starter clutch adjuster nut for Puch 2-speed ZA50 engines.*This is the adjuster nut only, as pictured. 

Puch NOS 12mm Connecting Rod Bushing - 12 x 14 x 12

NOS Puch connecting rod bushing. Comes with one lubrication hole.Will fit Vespa Piaggio mopeds such as the Ciao, Grande, Si, and Bravo. *Must have 12mm wrist pin. Dimensions:12(11.7)mm Inner...

NOS Puch Crankshaft Wrist Pin Bushing Reamer

This tool is designed to bore out a new connecting rod bushing in order to fit your wrist pin. Old Puch mopeds used copper bushing in the connecting rod and when they went bad either this was...

Fabric Puch Logo With Lightening Bolt Patch

fabric Puch logo with lightening bolt patch.Nicely made piece. Dimensions:84mm Long x 39mm Wide.

Medium Fabric Puch Logo Patch - 59mm

59mm fabric Puch logo patch.Nicely made piece. 

Small Fabric Puch Logo Patch - 54mm

54mm fabric Puch logo patch.Nicely made piece. 

Used Puch Moped Start / Stop Switch - Right side / No base

USED Puch start and stop switch. *Used and faded, but still functioning. This switch is for the right hand side on many old Puch mopeds and may fit other mopeds as well.  The base for this...

NOS Puch Moped Start / Stop Engine Switch - Chrome

Original Puch moped engine start / stop switch, made in Germany. Handlebar clamp included Run / Off only. Puch # 349.1.53.830

NOS Niox Headlight for Puch Dart "Mini Maxi", Pearly Moped

Original German made Puch Headlight Made by Niox. Puch logo stamped into the lens, high quality plastic lens. Very nice piece. Includes a 6v 15w P26S bulb, but you can also run a 12v...

NOS Puch Monza Moped Tank Decal / Sticker Pair - Blue, Green, White

NOS Puch Monza Tank Decal.  Comes with Two, one for each side.   Very old, May have a small bend.

NOS Puch Dart "Mini Maxi", Pearly Moped Headlight / Speedometer Shroud / Fairing - Red

Original Puch Dart known as the Mini Maxi in Europe headlight and speedometer shroud. Please compare and be sure this is the fairing you need.   Recommended Accessories: Headlight

NOS Puch Macho Round Headlight Moped Fairing - Red

Original NOS Puch Headlight fairing found on the Macho, but also is good for Maxi, Tomos and many other mopeds with 5"round headlights. They will not fit the Bullet style headlights.   Puch #...

NOS Original Puch Maxi Fork Set - Silver

NOS original forks for Puch mopeds. This will fit the Maxi, newport and similar models.  Nice silver paint and rust free chrome. 

NOS Puch Bulb Socket Clip for Non-Sealed Moped Headlights

Non-sealed Headlight socket Clip for CEV headlights. Puch Part # 349.2.53.807.1 For:  CEV 2157B Headlamp found on some models of: Batavus, Beta, Bianchi, Cimatti, Fantic, Garelli,...

NOS Puch Cobra / Monza Cylinder Stud m7 + m8 threads, 138mm Length *each*

Puch cylinder stud for the Cobra and Monza models. The bottoms are M8 thread and the top is m7 threading.      *Sold each*Please be sure to compare before purchasing Thread...

NOS Puch Magnum Moped Center Kickstand - Black

Original Puch Magnum XK and MKII Kickstand.  This is longer than the maxi versions.  Puch # 322.1.24.300.2/30

NOS Puch Maxi Moped Center Kickstand - Black

Original Puch Maxi Kickstand. Meant only for E50 models.  Puch # 349.5.24.500.2/30

Puch Moped E50 Engine Case - Bare Naked

Used Puch E50 engine case. Absolutely bare.

NOS Puch Maxi Swing arm - UPS brown

NOS Puch maxi swing arm. UPS brown. Includes the mounting plate, hardware, and bushing.  Will fit the Maxi, Swinger, Dart etc. As shown in pictures there are a few minor scuffs or scratches...

NOS Puch Moped ZA50 Case Gasket

Original Puch case gasket for ZA50 powered mopeds.   Puch # 321.2.10.631.1

NOS Puch Bombardier Side Frame Sticker *Right Side*

Awesome NOS Puch Bombardier decal. These were imported into Canada mostly and work on most Puch frames like the Maxi and Newport.  *Price is for EACH. This is the Right side...

NOS Puch Maxi Nostalgia Frame Sticker *Right Side*

Awesome NOS Puch decal. These were on a certain model Maxi moped but, now you can put them on yours! *Price is for EACH. This is Right(when sitting on moped) side only*   Recommended...

NOS Puch Maxi Nostalgia Frame Sticker *Left Side*

Awesome NOS Puch decal. These were on a certain model Maxi moped but, now you can put them on yours! *Price is for EACH. This is Left(when sitting on moped) side only*   Recommended...

Puch Moped Newport O/I Autostart Only Clutch Tool - 905.6.36.111.2

Use this when dissembling your Newport O/I (autostart)  only motor. use this to hold the clutch gear in place while taking the center nut off.

NOS Puch ZA50 Oil Fill Plug

Nos Puch oil fill plug for ZA50 2-speed equipped mopeds.