Original Kinetic TFR moped single speed clutch. Please please please compare before purchasing or send in pictures of your moped if not sure this is for you. May also fit the Piaggio Vespa Ciao.Single speeds only, not Variated models. Includes what...
Italian made Adige performance clutch innards for Single speed non-variating version models. This clutch plate and shoes must be used together as there are no pins like the original style. These do fit inside the stock clutch bell.
Original starter weights for Kinetic mopeds. Installation is based upon the moped. one way for Magnum models, the other for Luna Swift models. No springs, no rubber pads.
Kinetic Part # #05029590
High quality SKF non-sealed bearing Tomos and Motobecane mopeds. Known to fit the right side of Motobecane rear wheels (6200 bearing for left), works on Tomos A35 and A55 clutch covers
Please be sure to measure and compare bearing numbers before...
Puch one speed E50 Clutch bushing. Comes with two lubrication holes.Dimensions:14.9mm Inner Diameter17mm Outer Diameter21.4mm Longm**Please be sure to check specs and understand you may need to ream or sand to fit perfectly. Recommended...
Piaggio Vespa Ciao moped singles speed clutch pack top plate. Made for non variate models only. Dimensions:64.9mm(2.5") Diameter6.7mm(.26) High8mm Diameter Hole
Top quality Vespa Piaggio starter clutch segments set with springs. For variated Ciao, Bravo, Boxer, SI models only.
Made in Italy by Ferodo!
NOS starter clutch adjuster nut for Puch 2-speed ZA50 engines.*This is the adjuster nut only, as pictured.
Complete stock Motobecane 3 ball bearing variator assembly.Please be sure to check the unit before installation to be sure all hardware is secure.
Comes as shown.
Original Tomos 1st gear clutch hub. Used on A35 and A55 mopeds.
Tomos # 223429
New non variated Vespa Piaggio Ciao / Citta starter clutch segment set with springs.
Made in Italy.
Original Tomos Clutch Spring for A55 Mopeds. The softer "red" Clutch spring.Second gear on A55.
Tomos # 223769
Original Tomos Clutch Spring for A35 and A55 Mopeds. The stiffer "green" Clutch spring.First gear on A55.First and Second on A35
Survey says,,,, rated at 9.5lbs
Tomos # 209013
NOS Avanti starter clutch lever. Will work on Garelli VIP mopeds.
75mm Long shaft
10mm Diameter shaft
6mm Shaft end piece
Holds cable ends(knarps) from 3mm-10mm wide and up to 8mm in diameter.
Motobecane Flywheel clutch pad set Made for variated models only. Springs included.
Quality pads made in Europe.
Roughly 36mm long x 9mm wide
NOS OEM Tomos complete 1st gear clutch assembly.
Will fit A35 and A55 engine models.
Tomos part # 227018 (A35) & 227849 (A55)
Tech Tip: Soak in ATF/ gear oil overnight before use